Method to measure the amount of WEEE generated

Report to Nordic council's subgroup on EEE waste

image of Method to measure the amount of WEEE generated

The report compiles existing information about materials used for designing a top cover construction pursuant to Landfill Directive 1999/31/EC. The report includes a short review of existing requirements on top liners, especially in the Nordic countries. Accepting waste materials in top cover requires reliable information of both the technical and environmental properties. Important properties of waste material are listed, and factors to be considered in evaluating the functionality of the whole top cover construction are discussed. Key points in the evaluation of the suitability of waste materials in top cover are: the waste material fulfils the quality requirements and functions of the whole construction the quality variations of key properties are known and acceptable the long-term behaviour of the waste material is evaluated through pilot studies and proved reliable. This report describes the characteristics of the most typical waste materials used for designing top cover constructions. Moreover, a summary of Nordic studies on potential waste materials for top cover has been collated.



Evaluation of data sources on supply of EEE products

The reliability in the basic data is of decisive importance for the calculation result. However, the quality of the basic data is seldom fully satisfactory. It is therefore necessary to carry out a thorough assessment and possible correction of the basic data. The following sources of errors and assumptions should be evaluated together with the possibility of a correction


This is a required field
Please enter a valid email address
Approval was a Success
Invalid data
An Error Occurred
Approval was partially successful, following selected items could not be processed due to error